Ameritron ari-500 manual

 · 6 AMERITRON ARI ARI Automatic Band Switch for ALS Instruction Manual 6 jack on the back of the radio. This pin jack has the band data voltage, amp key out (goes to ground when the radio is transmitting), power with voltage when on, and ground. When the ARI is first turned on, the “Auto Information” (AI) command is sent to the radio. This command causes the Kenwood radio to output the state of the radio (frequency, mode, etc) anytime the state has changes. The ARI then uses the frequency to determine the appropriate band and then selects the correct antenna. follows these band changes. The ARI may be configured for automatic fault re-setting of the ALS if desired. These features make the ARI particularly convenient for contest operations. The ARI Automatic Band Switch includes an input for the ALSRC Remote Control Head, so both may be used simultaneously if desired.

Ameritron ARI Amplifier Radio Band Change and Keying Interfaces are designed to automatically select the correct frequency range on the Ameritron ALSM, ALS series and ALS amplifiers by reading data from the transceiver. The Ameritron ARI Amplifier Radio Interface reads band data from your Icom, Yaesu, Kenwood or Alinco transceiver so they can remotely and automatically bandswitch your ALSM amp. Lets you mount your ALSM out-of-the-way in your trunk. Works with serial numbers above (below requires the ARFK). ARI Automatic Band Switch for ALS Instruction Manual Skip this section and go to interfacing ARI to radio for keying and band data, if the ALSRC will not be used. The optional ALSRC remote head can be used with the ARI The ALSRC will display the current, power on, TX and O/L of the amplifier.

OK Charlie - yes, Ameritron uses a similar DB9 cable for CAT control Your Acom does the same as my ARI, it converts serial data rig. PDF. Radio Cables: A diagram of each cable set is available by clicking on the Amplifier interface cable for Ameritron ALS/ with ARI 3 feb Along with the ', I'm using an Ameritron ALSM in Can't find specific instructions for the ARI to ICALS